We’re building another dungeon, this time the Undermountain. The Undermountain is a series of tunnels and rooms that once belonged to a dwarven stronghold, but have been taken over by an ancient wyrm and its devout goblin worshipers. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across:

• Print One – Enter the Undermountain
• Print Two – The Sundered Spire
• Print Three – Portals
• Print Four – [Destroyed Portal – The Vortex]()

Destroyed Portal – The Vortex

The Sundered Spire sits before a short hallway, at the end of which was once another portal. Whatever managed to destroy the spire seems to have also destroyed the portal – where once a magic circle would have been etched into the floor is now a swirling pool of water, at its center a never ending vortex of water leading down:

View this post on Instagram

A post shared by Dwyer Devices (@dwyerdevices)

Where does the water go? Where does the water come from? Hopefully our adventurers never find out.

• Makers:
  • Circle floor exterior: devonjones
  • Vortex Pool: patricknevindwyer
• Sources:
  • OpenForge – Magic Circles
  • Vortex Pool
• Licenses: Creative Commons – Attribution – Share Alike
• Models:
  • circle_floor_1-exterior.stl
  • vortex_pool.stl
• GCode: –
• Material:
  • Gizmodorks Translucent Blue PLA 1.75mm
  • Inland Grey ABS 1.75mm
• Print Date: 2017/11/4 – 2017/11/15
• Print Time:
  • basin: 57 minutes
  • water vortex: 3 hours 22 minutes
• Estimated Print Time:
  • basin: 42 minutes
  • water vortex: 3 hours 8 minutes
• Estimated Filament:
  • border: 6.1 meters
  • water vortex: 12.3 meters
• Slicer: Slic3r
• Slicer Settings:
  • 0.20mm layers
  • 10mm brim
  • no supports
• Printer: Prusa i3 mk2