It was edging close to Halloween, and I just happened to have some translucent green and translucent orange filament on hand (imagine that), so a Jack-o-lantern seemed appropriate:
Lit with a small LED, it had a nice glow to it:
This is one of only a handful of models I’ve need to scale up for printing. In this case I wanted to fit a tea candle LED, which required scaling up to 150% of original size to get the LED through the opening at the top of the pumpkin.
- Maker: skriver
- Source: Makies Jack-o-Lantern
- License: Creative Commons – Attribution – Share Alike
- Model: all parts
- GCode: –
- Materials:
- Inland Translucent Orange PETG 1.75mm
- CNZhehan Translucent Green PETG 1.75mm
- Print Date: 2017/10/20
- Print Time:
- Body: 7 hours 28 minutes
- Lid: 1 hour 23 minutes
- Stem: 20 minutes
- Estimated Print Time:
- Body: 6 hours 47 minutes
- Lid: 1 hour 19 minutes
- Stem: 19 minutes
- Estimated Filament:
- Body: 27.2 meters
- Lid: 4.7 meters
- Stem: 58.2 cm
- Slicer: PrusaControl
- Slicer Settings:
- 0.20mm layers
- Include Supports
- Include brim
- 20% infill
- 150% scale
- Printer: Prusa i3 mk2